Skip to content

Thermal Inspection

Heat shows a fault long before a meter does. We survey solar plants, switchgear and building envelopes thermally, and hand you a report that says what is wrong and exactly where.

What we inspect

Photovoltaic installations: hot spots, failed bypass diodes, disconnected or underperforming strings, soiling patterns, located per module so your O&M team goes straight to the panel. Electrical installations: switchgear, terminals, busbars, drives and motors surveyed under representative load, which is the only condition in which a loose connection actually shows up. Building envelopes: thermal bridges, missing or wet insulation, air leakage and heat loss across roofs and facades.

How a survey runs

We agree the scope and the conditions first, because thermography is only as good as the conditions it is flown or walked in: PV surveys need irradiance above a threshold and a stable sky; electrical surveys need the installation running under real load. On site we capture radiometric imagery: aerially for plants and roofs, on foot for panels and machinery. You receive a report per asset: thermal and visual image side by side, measured delta-T, location reference, a severity classification, and a recommendation. Findings are prioritised so you can plan the fix, not just react to it.

What you receive

  • Radiometric report per finding: thermal + visual image, delta-T, location
  • Severity classification and prioritised recommendations
  • For PV: per-module fault mapping over the plant layout
  • Georeferenced overview of the surveyed asset
  • Debrief with your maintenance or O&M team

Frequently asked questions

What conditions do you need for a valid thermal survey?

For PV, sufficient and stable irradiance and a low-wind window. We schedule around it rather than fly and deliver weak data. For electrical installations, the system must run under representative load; surveying an idle panel finds nothing. We tell you up front if a requested date will not produce usable results.

Do you need to shut down the installation?

No, quite the opposite. Thermal inspection is done with everything running, which is precisely why it is useful: you find the developing fault without the production stop that finding it any other way would cost.

What do we actually receive at the end?

A report you can hand to a maintenance team and act on: every finding with its thermal and visual image, measured temperature difference, exact location, severity and recommended action, not a folder of raw images.